NEC SL1100 - Page 565

Alarm
No.
Type
Re-
port
Name
Content of
Alarm
Cause Action Recovery
Alarm
Status
17 1 0 Denial of
service
The system re-
ceived illegal
packet.
Service outage
(Dos attack)
Confirm whether to
find abnormality on
the net side.
WAR
18 1 0 Connec-
tion Error
Digital Station
Wiring Error
The wiring connec-
tion between the
Multiline terminal
and the system
has an issue.
Check all wiring in
between the Multi-
line terminal and
the digital station
card.
MAJ
30 2 0 SMDR
Buffer full
The temporary
buffer for SMDR
in main device
overflowed, and
a part of output
SMDR data dis-
appeared be-
cause it could
not output
SMDR data.
1. Problem of
wiring to con-
nect main de-
vice with PC.
2. PC Problem.
1. Confirm
whether there
is problem in
wiring to con-
nect a main
device with
PC.
2. Execute the
reactivation of
PC.
When the
output is re-
started, the
error is recov-
ered.
However, the
SMDR data
after the error
occurs is not
recorded.
ERR
REC
31 1 0 Security
Sensor
detected
Sensor detected
abnormality.
Sensor detected
abnormality.
Especially, any-
thing need not be
done.
INF
32 1 0 Automatic
Transmis-
sion from
Remote
Surveil-
lance
Remote watch
function did auto
dialing.
Remote watch
function did auto
dialing.
Especially, any-
thing need not be
done.
INF
50 1 0 System
Start Noti-
fication
The system
started.
The system was
started.
No action needed.
51 0 0 System
Data
change
CPU Upgrade is
performed or
Programming
change is made.
No action needed.
54 2 0 License
Manage-
ment Ta-
ble Full
A new TCP/IP
terminal and the
DSP board were
not able to be
added to the ap-
plication license
management ta-
ble.
• The license
management
table is regis-
tering full.
Maximum 512 li-
cense information
on the TCP/IP ter-
minal is registered,
and a new terminal
cannot be regis-
tered.
Please delete li-
cense information
on an unnecessary
TCP/IP terminal
with Program
90-44.
WAR
55 2 0 Regular
mainte-
nance ex-
change
notifica-
tion.
The regular
maintenance
exchange day
has passed.
• The regular
maintenance ex-
change day that
had been set
with Program
90-51 exceeded
it.
Please do the
maintenance ex-
changes of perti-
nent parts, and set
the next regular
maintenance ex-
change day with
Program 90-51.
The excess
on the regular
maintenance
exchange
day is can-
celed by
changing
Program
90-51 or
when the
function is in-
validated, the
error is recov-
ered.
ERR
REC
ISSUE 6.0 SL1100
Programming Manual 2-545
Program
90