Newtec MDM9000 - Software Upgrade (CLI)

Newtec Proprietary
Confidentiality: Unrestricted
R3.2_v1.0
93/387
How to Manage the Device
MDM9000 Satellite Modem
[MDM9000] # device identification label get
Modulator
or
It is also possible to navigate to the parameter location and make a request.
[MDM9000] # mgmtintf
[MDM9000] mgmtintf # mgmtgateway get
192.168.254.206
or
Request a parameter from another sub branch.
[MDM9000]# /modulator mode get
Dvbs2
Set
For example (change only one parameter):
[MDM9000] modulator# outputlevel set -15dbm
OK
For example (change multiple parameters):
[MDM9000] modulator# set outputlevel=-25dbm outputfrequency=1550.000000 MHz
13.7.12 Software Upgrade (CLI)
Make sure that the upgrade file (installer.bin) is uploaded to your MDM9000.
To do this use the FTP to upload the installer.bin file. Please refer to:
FTP(FileTransferProtocol).onpage99
When the upgrade file is available use the CLI to perform the software upgrade.
» Login as expert
MDM9000]# device
MDM9000 device]# softwareupgrade filename=installer_MDM9000_1.3.bin reboot=yes
***hardware reset requested***
OK
Make sure that to use the correct filename, the previous is just an example!