Newtec MDM9000 - TS Encapsulation Pids

Newtec Proprietary
Confidentiality: Unrestricted
R3.2_v1.0
249/387
Feature Descriptions
MDM9000 Satellite Modem
16.11.3.2 TS Encapsulation PIDs
Parameter Description
Name
Enter a logical unique name.
Note: A unique name is proposed by the device.
Enable
Enable the creation of PIDs.
This adds a Program Identifier to the transport stream packet that is
being created.
This is needed by the receiver, to filter out this specific program.
PID
Enter the Program Identifier number. This number is added to the
header transport stream. It will be used by the decapsulator on the
receiver site.
ISI
Select one of the available ISI names.
The available names are defined under ISIs.
Protocol
Here you have the possibility to overrule the default protocol that has
been selected under the general encapsulation settings.
Refer to EncapsulationGeneralSettingsonpage230.
Nominal DVB-S2
MODCOD
Select the ModCod to be used (overruled when ACM is
enabled).(overruled when ACM is enabled).
ACM Enable This configuration guideline does not cover ACM.