Newtec MDM9000 - Set Date and Time

Newtec Proprietary
Confidentiality: Unrestricted
R3.2_v1.0
41/387
Getting Started
MDM9000 Satellite Modem
Note that only device specific parameter settings are automatically saved.
All other parameters require an explicit save action!
To get an overview of the device specific parameters we refer to section
ConfigurationFileonpage107 .
Make sure that the management PC has access to this IP address or it belongs to this
IP range.
If needed it is possible to configure the Mgmt Gateway.
To configure the Mgmt Gateway
» Navigate to Mgmt Itf
» Navigate to Gateway
» Enter the correct Gateway address
» Click OK
Now it is possible to access the device from a management PC.
11.2 Set Date and Time
It is advised to set the device date and time according to your time zone.
» Select Device from the corresponding soft button.
» Navigate to Date and Time.
» Press OK (to unfold the branch).
» Navigate to Date or Time and press OK.
» Use the navigation down button to display numerical values.
» Use the Soft Buttons to enter a new Date or Time.
» Press OK to confirm the setting.