Newtec Proprietary
Confidentiality: Unrestricted
R3.2_v1.0
40/387
Getting Started
MDM9000 Satellite Modem
11 Getting Started
Use this guide to configure the management IP Address of the device and save it as a boot
configuration. Once this is done, it is possible to access the device using one of the following
operational interfaces:
• GUI
• CLI
• SNMP
Refer to the reference manual to check the factory default values of the device.
Please also refer to the Configuration Guidelines for a point to point setup between
two MDM9000 devices.
11.1 Set the Management IP Address
The factory default of the Mgmt IP Address is: 10.0.0.1/24 on Mgmt1 Ethernet
interface.
» Insert the power cable to start the device.
» Wait until the welcome menu disappeared and the menu tree is displayed on the front panel.
» Select Mgmt Itf using the corresponding Soft Button.
» Navigate to IP Address.
» Press OK (to unfold the branch).
» Navigate to Mgmt1.
» Press OK.
» Press OK to select the IP Address/Prefix.
» Use the Soft Buttons to enter a new IP Address/Prefix.
» Press OK to confirm and save the setting.
» Connect an Ethernet cable between the Mgmt1 port on the back panel of the MDM9000 and the
management PC. (The state indication on the front panel is changed from off to on).
To Next Page
Loading...
