Newtec Proprietary
Confidentiality: Unrestricted
R3.2_v1.0
124/387
General Device Settings and Actions
MDM9000 Satellite Modem
Redundant Operation
To Enable or Disable device redundancy go to the following location:
MDM9000 >> Redundancy
When device redundancy is enabled, the USS controls the actual operational redundancy state.
By default, device redundancy is disabled.
Initial Redundancy State:
• Standby (default value): This means when the device starts up and redundancy is enabled, the
initial state of the redundancy is standby. Typically:
– The modulator output is disabled.
– No IP Address on the data interface.
• Active.
To Next Page
Loading...
