Newtec Proprietary
Confidentiality: Unrestricted
R3.2_v1.0
235/387
Feature Descriptions
MDM9000 Satellite Modem
Parameter Description
Optimized for ACM This is the default setting, it optimizes the bandwidth usage by delaying
BBFs until they are completely filled with traffic data prior to effectively
transmitting them. The encapsulation interval and packing time are
dynamically set to allow optimal BBF efficiency even in case of bursty
traffic. This approach leads to the highest filling levels off the BBFs and
hence the highest efficiency on the link. On the downside, it introduces
a slightly variable amount of delay and additional jitter when dealing with
low rate and bursty traffic. Use this mode for higher rate, continuous
(quasi non-bursty) traffic.
Optimize for jitter This mode is preferred for low speed links with bursty traffic and
applications that are jitter sensitive as it will automatically lower the
encapsulation interval and packing time. This mode might lead to a slight
reduction in link efficiency as the BBFs are sent out at a steady pace
whether they are completely filled or not. This non-optimal link filling
efficiency is not so important as the link's filling level is variable anyhow
when dealing with bursty traffic.
For low speed links it is also advised to use short frames and
encapsulate all traffic (data and control plane) into the same ISI.
Manual
This mode allows for manually setting the encapsulation interval and
packing time for specific applications. Use this mode only under
guidance of Newtec Customer Support.
Use the Newtec Service Desk tool to receive more
information.
> Browse to https://customersupport.newtec.eu.
> Fill in your Username and Password
> Create a ticket
As response of your request you will receive appropriate
feedback from our support team.
In case you don't have a Username and Password yet for
the Newtec Service Desk tool: request a login to
customersupport@newtec.eu.
To Next Page
Loading...
