EasyManua.ls Logo

Newtec MDM9000 - Page 66

Default Icon
400 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Newtec Proprietary
Confidentiality: Unrestricted
R3.2_v1.0
54/387
How to Manage the Device
MDM9000 Satellite Modem
MDM9000 >> Device Setup >> Mgmt Interface >> IP Address >> Link Redundancy
When link redundancy is activated, the Mgmt interface (bond interface) becomes
active. This Mgmt interface has an IP Address that is used as destination address by
the source.
It is recommended to configure the connected switch/router-ports in portfast mode.
Otherwise a spanning tree protocol event could cause a blocked port towards the
MDM9000.
In a typical Cisco switch configured using rapid spanning tree this is achieved by
setting the ports in portfast mode.

Table of Contents

Related product manuals