7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
uplinkA-vlan 0
uplinkA-route xxx.xxx.x.x/16 next-hop xxx.xxx.xx.x
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
primary-image ftp://*:*@xx.xxx.xx.xxx/./images/SASS-hops-both.tim
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address xx.xxx.xx.xxx/24 active
eth-mgmt-route xx.xxx.x.x/16 next-hop xx.xxx.xx.xxx
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
primary-image uf1:both.tim
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/25
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 10000
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/26
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 10000
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
4.11.3.3 Accessing the CLI
To access the CLI to configure the software for the first time, follow these steps:
1. When the power to the chassis is turned on, the 7210 SAS software automatically begins the boot
sequence.
2. When the boot loader and BOF image and configuration files are successfully located, establish a router
connection (console session).
See Console connection for information about establishing a console connection.
4.11.3.4 Configuring BOF encryption
The BOF contents can be encrypted using AES256 and integrity information maintained using SHA256.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
161
SPACER TEXT
To Next Page
Loading...