7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Use the following CLI syntax to configure BOF encryption.
bof
encrypt {on | off}
4.11.3.5 Configuring the BOF interactive menu password
The 7210 SAS supports the configuration of a BOF password to provide specific users with access to the
BOF interactive menu. To securely store the BOF password, use the bof secure-bof-password command.
Use the following CLI syntax to configure and securely store a password for the BOF interactive menu.
bof
bof-password password
no bof-password
secure-bof-password {enable | disable}
The password must be a plaintext string, between 8 and 32 characters, and cannot contain embedded
nulls.
Caution:
When entering the password in plaintext, ensure that the password is not visible to bystanders.
4.11.3.6 Configuring the configuration file encryption
The configuration file contents can be encrypted using AES256 and integrity information maintained using
SHA256.
Use the following CLI syntax to configure an encryption key for the configuration file.
bof
encryption-key key
no encryption-key
The configured encryption key must be a plaintext string, between 8 to 32 characters, and cannot contain
embedded nulls.
Caution:
When entering the encryption key in plaintext, ensure that the key is not visible to bystanders.
4.11.3.7 Console connection
To establish a console connection, you will need the following:
• an ASCII terminal or a PC running terminal emulation software set to the parameters described in Table
22: Console configuration parameter values
• a standard serial cable connector for connecting to a RS232 port (provides a RJ45 connector)
The following table lists the console configuration parameter values.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
162
SPACER TEXT
To Next Page
Loading...