EasyManua.ls Logo

Nokia 7210 SAS-Mxp - Page 174

Nokia 7210 SAS-Mxp
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
A:*A:sim169##
4.12.1.2 Modifying and saving a configuration
If you modify a configuration file, the changes remain in effect only during the current power cycle unless
a save command is executed. Changes are lost if the system is powered down or the router is rebooted
without saving:
Specify the file URL location to save the running configuration. If a destination is not specified, the files
are saved to the location where the files were found for that boot sequence. The same configuration can
be saved with different filenames to the same location or to different locations.
The detail option adds the default parameters to the saved configuration.
The index option forces a save of the index file.
Changing the active and standby addresses without reboot standby CPM may cause a boot-env
synchronization to fail.
Use the following command syntax to save a configuration.
bof# save [cflash-id]
Example: Saving a configuration
A:ALA-1# bof
A:ALA-1>bof# save cf1:
A:ALA-1>bof#
Use the following command syntax to save the system configuration.
admin# save[file-url][detail][index]
Example: Saving the system configuration
A:ALA-1# admin save cf1:\test123.cfg
Saving config.# Saved to cf1:\test123.cfg
... complete
A:ALA-1#
Note:
If the persist option is enabled and the admin save file-url command is executed with an FTP
path used as the file-url parameter, two FTP sessions simultaneously open to the FTP server.
The FTP server must be configured to allow multiple sessions from the same login; otherwise, the
configuration and index files will not be saved correctly.
4.12.1.3 Deleting BOF parameters
You can delete specific BOF parameters. The no form of these commands removes the parameter from
configuration. The changes remain in effect only during the current power cycle unless a save command is
executed. Changes are lost if the system is powered down or the router is rebooted without saving.
Deleting the BOF and rebooting causes the system to enter the auto mode.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
174
SPACER TEXT

Table of Contents

Related product manuals