Nokia 7210 SAS-Mxp - Page 175

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Use the following CLI syntax to save and remove BOF configuration parameters.
bof# save [cflash-id]
Example: Saving a BOF configuration
A:ALA-1# bof
A:ALA-1>bof# save cf1:
A:ALA-1>bof#
Example: Removing BOF parameters
*A:7210>bof#
no console-speed
no dns-domain
no eth-mgmt-address
no eth-mgmt-autoneg
no eth-mgmt-disable
eth-mgmt-duplex
no eth-mgmt-route
eth-mgmt-speed
persist
no ping-address
no primary-config
no primary-dns
no primary-image
save
no secondary-config
no secondary-dns
no secondary-image
no tertiary-config
no tertiary-dns
no tertiary-image
no uplinkA-address
no uplinkA-autoneg
no uplinkA-duplex
no uplinkA-speed
no uplinkA-port
no uplinkA-route
no uplinkA-vlan
no uplinkB-address
no uplinkB-autoneg
no uplinkB-duplex
no uplinkB-speed
no uplinkB-port
no uplinkB-route
no uplinkB-vlan
wait
4.12.1.4 Saving a configuration to a different filename
Save the current configuration with a unique filename to have additional backup copies and to edit
parameters with a text editor. You can save your current configuration to an ASCII file.
Use one of the following CLI syntax to save a configuration to a different location.
bof# save [cflash-id]
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
175
SPACER TEXT