7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
uplinkB-vlan
Syntax
uplinkB-vlan 0..4094
no uplinkB-vlan
Context
bof
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and
access-uplink mode)
Description
This command configures a VLAN ID to be used on uplinkB.
The no form of this command is used to send untagged packets on uplinkB.
Parameters
0...4094
Specifies the VLAN ID.
Values 0 to 4049
eth-mgmt-address
Syntax
[no] eth-mgmt-address ip-prefix/ip-prefix-length [active | standby]
Context
bof
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command assigns an IP address to the management Ethernet port in the running configuration and
the BOF. Deleting a BOF address entry is not allowed from a telnet session.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
203
SPACER TEXT
To Next Page
Loading...