Nokia 7210 SAS-Mxp - Page 206

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command configures the duplex mode of the management Ethernet port when auto-negotiation is
disabled in the running configuration and the BOF.
This configuration command allows for the configuration of the duplex mode of the Ethernet port. If the port
is configured to auto-negotiate, this parameter will be ignored.
Default
eth-mgmt-duplex full
Parameters
full
Keyword to set the link to full duplex mode.
half
Keyword to set the link to half duplex mode.
eth-mgmt-route
Syntax
[no] eth-mgmt-route ip-prefix/ip-prefix-length next-hop ip-address
Context
bof
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command configures a static route entry for the management Ethernet port in the running
configuration and the BOF.
This command allows manual configuration of static routing table entries. These static routes are only used
by traffic generated by the Ethernet port. To reduce configuration, manual address aggregation should be
applied where possible.
A static default (0.0.0.0 or 0) route cannot be configured on the management Ethernet port. A maximum of
ten static routes can be configured on the management Ethernet port.
The no form of this command deletes the static route.
Parameters
ip-prefix\ip-prefix-length
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
206
SPACER TEXT