7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
xyz.cfg.2
xyz.cfg.3
xyz.cfg.4
xyz.cfg.5
xyz.ndx
Each persistent index file is updated at the same time as the associated configuration file. When the
index file is updated, the save is performed to xyz.cfg and the index file is created as xyz.ndx.
Synchronization between the active and standby is performed for all configurations and their associated
persistent index files.
Use the following syntax to specify the maximum number of backup versions of the configuration and index
files kept in the primary location.
config>system
config-backup count
Example: Command usage
The following example shows the command usage to set the maximum number of backup versions of the
configuration and index files kept in the primary location to 7.
config>system#
config>system# config-backup 7
Example: Configuration output for the config-backup command
A:ALA-12>config>system>time# info
#------------------------------------------
echo "System Configuration"
#------------------------------------------
name "ALA-12"
contact "Fred Information Technology"
location "Bldg.1-floor 2-Room 201"
clli-code "abcdefg1234"
coordinates "N 45 58 23, W 34 56 12"
config-backup 7
...
----------------------------------------------
A:ALA-12>config>system>time#
6.15 System administration parameters
This section describes the system administration parameters and the CLI syntax to configure the
parameters.
6.15.1 Disconnect
The disconnect command immediately disconnects a user from a console, Telnet, FTP, or SSH session.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
313
SPACER TEXT
To Next Page
Loading...