7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Note:
Configuration modifications are saved to the primary image file.
Use the following syntax to disconnect a user from a session.
admin
disconnect [address ip-address |username user-name |{console|telnet|ftp|ssh}]
Example: Command usage to disconnect a user from a session
admin# disconnect
Example: Output of the disconnect command
ALA-1>admin# disconnect
ALA-1>admin# Logged out by the administrator
Connection to host lost.
C:\>
6.15.2 Set-time
Use the set-time command to set the system date and time. The time entered should be accurate for
the time zone configured for the system. The system will convert the local time to UTC before saving to
the system clock, which is always set to UTC. If SNTP or NTP is enabled (no shutdown), this command
cannot be used. The set-time command does not take into account any daylight saving offset, if defined.
Use the following syntax to set the date and time.
admin
set-time date time
Example: Command usage to set the date and time
admin# set-time 2007/02/06 04:10:00
Example: Output of the set-time command
ALA-2# admin set-time 2007/02/06 04:10:00
ALA-2# show time
Thu Feb 2 04:10:04 GMT 2007
ALA-2#
6.15.3 Display-config
The display-config command displays the running configuration of the system.
Use the following syntax to display the running configuration of the system.
admin
display-config [detail] [index]
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
314
SPACER TEXT
To Next Page
Loading...