7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Parameters
clli-code
Specifies the 11 character string CLLI code. Any printable, seven bit ASCII characters can
be used within the string. If the string contains special characters (#, $, spaces, and so on),
the entire string must be enclosed within double quotes. If more than 11 characters are
entered, the string is truncated. If less than 11 characters are entered the string is padded
with spaces.
config-backup
Syntax
config-backup count
no config-backup
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures the maximum number of backup versions maintained for configuration files and
BOF.
For example, assume count is set to 5, and the configuration file is called xyz.cfg. When a save
command is executed, the file xyz.cfg is saved with a .1 extension. Each subsequent config-backup
command increments the numeric extension until the maximum count is reached.
xyz.cfg
xyz.cfg.1
xyz.cfg.2
xyz.cfg.3
xyz.cfg.4
xyz.cfg.5
xyz.ndx
Each persistent index file is updated at the same time as the associated configuration file. When the
index file is updated, the save is performed to xyz.cfg and the index file is created as xyz.ndx.
Synchronization between the active and standby is performed for all configurations and their associated
persistent index files.
The no form of this command reverts the configuration to the default value.
Default
5
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
355
SPACER TEXT
To Next Page
Loading...