Nokia 7210 SAS-Mxp - Page 364

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Parameters
time in seconds
Specifies the time, in seconds.
Values 0 to 3600
vwm-shelf
Syntax
[no] vwm-shelf vwm-shelf-id [create]
Context
config>system
Platforms
7210 SAS-R6 and 7210 SAS-R12
Description
Commands in this context configure the shelf information for 1830 VWM clip-on device.
The user must create the VWM clip-on device and provision the shelf ID to allow the 7210 SAS software
to communicate with the shelf and retrieve information. The value specified in the vwm-shelf-id parameter
must match the shelf ID set using the rotary dial on the clip-on device. If these shelf IDs do not match, the
7210 SAS devices will not be able to interact to the device and does not provide any information about the
device. The software cannot detect a mismatch between the value of the configured vwm-shelf-id and the
shelf ID set on the rotary dial.
In prior releases, the software allows user to configure only a single clip-on device for management by
specifying a single shelf ID. The software does not allow for configuration of more than a single clip-on
shelf.
A fixed number of 1830 VWM devices can be managed by the 7210 SAS devices. The limit depends
on the interface used to connect to the 1830 device. The user must provision all the shelves that are
connected to the 7210 SAS device.
The no form of this command removes the configured shelf ID and the software removes all the
information it has for the shelf.
Parameters
vwm-shelf-id
Specifies the 1830 VWM clip-on device attached to a 7210 SAS device.
Values 1 to 7
Note:
The vwm-shelf-id can take values in the range 1 to 7. This
implies that the rotary switch on the connected optical clip-on
device must be set to a value in this range.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
364
SPACER TEXT