Nokia 7210 SAS-Mxp - Page 399

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
The no form of this command deletes the specified PTP port.
Parameters
port-id
Specifies a physical port.
Values slot/mda/port
create
Keyword to create the PTP port.
address
Syntax
address {01:1b:19:00:00:00 | 01:80:c2:00:00:0e}
Context
config>system>ptp>port
Platforms
7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx 1/10GE (standalone), 7210 SAS-Sx
10/100GE 64SFP+ 4QSFP28 (standalone), 7210 SAS-T (network and access-uplink)
Description
This command configures the MAC address to be used as the multicast destination MAC address for
transmitted PTP messages.
This command applies only if the PTP profile is set to g8275dot1-2014.
The IEEE Std 1588-2008 Annex F defines two reserved addresses for PTP messages:
• 01-1B-19-00-00-00 — for all messages except peer delay mechanism messages
• 01-80-C2-00-00-0E — for peer delay mechanism messages
The system accepts PTP messages received using either destination MAC address, regardless of the
address configured by this command.
Default
01:1b:19:00:00:00
master-only
Syntax
master-only {true | false}
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
399
SPACER TEXT