7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Description
This command enables listening to SNTP/NTP broadcast messages on interfaces with broadcast client
enabled at global device level.
If this global parameter is configured, the ntp-broadcast parameter must be configured on selected
interfaces on which NTP broadcasts are transmitted.
SNTP must be shutdown prior to changing either to or from broadcast mode.
The no form of this command disables broadcast client mode.
Default
no broadcast-client
server-address
Syntax
server-address ip-address [version version-number] [normal | preferred]
[interval seconds]
no server-address
Context
config>system>time>sntp
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command creates an SNTP server for unicast client mode.
Parameters
ip-address
Specifies the IP address of the SNTP server.
version version-number
Specifies the SNTP version supported by this server.
Values 1 to 3
Default 3
normal | preferred
Specifies the preference value for this SNTP server. When more than one time-server is
configured, one server can have preference over others. The value for that server should
be set to preferred. Only one server in the table can be a preferred server.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
413
SPACER TEXT
To Next Page
Loading...