Nokia 7210 SAS-Mxp - Page 428

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command enables the TOD suite ingress parameters.
filter
Syntax
filter ipip-filter-id [time-range time-range-name] [priority priority]
no filter ip ip-filter-id [time-range time-range-name]
filter ipv6ipv6-filter-id [time-range time-range-name] [priority priority]
no filter ipv6 ipv6-filter-id [time-range time-range-name]
filter macmac-filter-id [time-range time-range-name] [priority priority]
no filter mac mac-filter-id [time-range time-range-name]
Context
config>system>cron>tod-suite>egress
config>system>cron>tod-suite>ingress
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command creates time-range based associations of previously created filter policies. Multiple policies
may be included and each must be assigned a different priority; in case time-ranges overlap, the priority
will be used to determine the prevailing policy. Only a single reference to a policy may be included without
a time-range.
Parameters
ip-filter ip-filter-id
Specifies an IP filter for this tod-suite.
Values 1 to 65535
ipv6-filter ip-filter-id
Specifies an IPv6 filter for this tod-suite.
Values 1 to 65535
time-range time-range-name
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
428
SPACER TEXT