Nokia 7210 SAS-Mxp - Page 436

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
The no form of this command removes the file location from the configuration. Scripts will not execute if
there is no result location defined.
Default
no results
Parameters
file-url
Specifies the location to send the CLI output from script runs. The file-url is a location,
directory, and filename prefix to which a data and timestamp suffix is added when the
results files are created during a script run, as follows:
file-url_YYYYMMDD-hhmmss.uuuuuu.out
where: YYYYMMDD — date
hhmmss — hours, minutes, and seconds
uuuuuu — microseconds (padded to 6 characters with leading zeros)
Values file-url — local-url | remote-url
local-url — [cflash-id/] [file-path]
255 chars maximum, including cflash-id directory length 99 characters
maximum each
remote url — [{ftp:// | tftp://}| login:password@remote-location/][file-
path]
255 characters maximum
directory length 99 characters maximum each
remote-location — [hostname | ipv4-address | ipv6-address]
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
interface — 32 characters maximum, for link local addresses
cflash-id — cf1:
usb-flash-id — uf1:
6.20.2.1.13 System time commands
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
436
SPACER TEXT