7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
output
Syntax
output
Context
config>system>sync-if-timing>bits1
config>system>sync-if-timing>bits2
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
Commands in this context configure the external BITS timing reference output from the node. The user has
the option to enable or disable the BITS interface output independently of each other.
Note:
• The 7210 SAS-R6 and 7210 SAS-R12 only support the configuration of the BITS1 interface
for use as an input or output reference.
• The 7210 SAS-T and 7210 SAS-Mxp support the configuration of both BITS1 and BITS2
interface as an input and output reference.
• On the 7210 SAS-T and 7210 SAS-Mxp, the BITS1 configuration parameters such as bits-
interface-type, line-length, source-reference, and so on, are inherited for the BITS2 interface.
CLI commands are available to administratively control the BITS2 interface, allowing the user
to shutdown or enable the BITS2 input and output independently of the BITS1 interface.
interface-type
Syntax
interface-type {ds1 [{esf | sf}] | e1 [{pcm30crc | pcm31crc}]}
no interface-type
Context
config>system>sync-if-timing>bits1
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
This command configures the BITS port to support one of the available interface types, through T1/DS1 or
E1 synchronization interface and the desired framing with that interface type.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
446
SPACER TEXT
To Next Page
Loading...