7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Context
config>system>sync-if-timing>bits2>input
config>system>sync-if-timing>bits2>output
Platforms
7210 SAS-T (network and access-uplink) and 7210 SAS-Mxp
Description
This command administratively disables the entity. When disabled, an entity does not change, reset, or
remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
The no form of this command places the entity into an administratively enabled state.
Default
no shutdown
input
Syntax
input
Context
config>system>sync-if-timing>bits1
config>system>sync-if-timing>bits2
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
Commands in this context configure the external BITS timing reference input from the node. The user has
the option to enable or disable the BITS interface input independently of each other.
Note:
• The 7210 SAS-R6 and 7210 SAS-R12 only support the configuration of the BITS1 interface
for use as an input or output reference.
• The 7210 SAS-T and 7210 SAS-Mxp support the configuration of both BITS1 and BITS2
interface as an input and output reference.
• On the 7210 SAS-T and 7210 SAS-Mxp, the BITS1 configuration parameters such as bits-
interface-type, line-length and source-reference are inherited for the BITS2 interface. CLI
commands are available to administratively control the BITS2 interface, allowing the user to
shutdown or enable the BITS2 input and output independently of the BITS1 interface.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
445
SPACER TEXT
To Next Page
Loading...