7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
This command administratively disables the entity. When disabled, an entity does not change, reset, or
remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
The no form of this command places the entity into an administratively enabled state.
Default
no shutdown
bits2
Syntax
bits2
Context
config>system>sync-if-timing
Platforms
7210 SAS-T (network and access-uplink) and 7210 SAS-Mxp
Description
Commands in this context configure parameters for the Building Integrated Timing Supply (BITS).
Note:
• The 7210 SAS-R6 and 7210 SAS-R12 only support the configuration of the BITS1 interface
for use as an input or output reference.
• The 7210 SAS-T and 7210 SAS-Mxp support the configuration of both BITS1 and BITS2
interface as an input and output reference.
• On the 7210 SAS-T and 7210 SAS-Mxp, the BITS1 configuration parameters such as bits-
interface-type, line-length, source-reference, and so on, are inherited for the BITS2 interface.
CLI commands are available to administratively control the BITS2 interface, allowing the user
to shutdown or enable the BITS2 input and output independently of the BITS1 interface.
shutdown
Syntax
[no] shutdown
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
444
SPACER TEXT
To Next Page
Loading...