7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode; not supported on 7210 SAS platforms configured in the standalone-VC
operating mode
Description
This command creates or edits the system synchronous interface timing configuration.
bits1
Syntax
bits1
Context
config>system>sync-if-timing
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
Commands in this context configure parameters for the Building Integrated Timing Supply (BITS).
Note:
• The 7210 SAS-R6 supports the configuration of only the BITS1 interface for use as an input or
output reference. The 7210 SAS-R12 has only a single BITS port on the front panel, unlike the
7210 SAS-R6, which has two ports. Therefore, this command is invalid for the 7210 SAS-R12.
• The 7210 SAS-T and 7210 SAS-Mxp allow for configuration of both BITS1 and BITS2
interface as an input and output reference.
• On the 7210 SAS-T and 7210 SAS-Mxp, the BITS1 configuration parameters such as bits-
interface-type, line-length, and source-reference are inherited for BITS2 interface. CLI
commands are available that provide the user an option to administratively control the BITS2
interface, allowing them to shutdown or enable the BITS2 input and output independently of
BITS1 interface. Read the other commands for more information.
shutdown
Syntax
[no] shutdown
Context
config>system>sync-if-timing>bits1>input
config>system>sync-if-timing>bits1>output
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
443
SPACER TEXT
To Next Page
Loading...