Nokia 7210 SAS-Mxp - Page 450

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
config>system>sync-if-timing>ref1
config>system>sync-if-timing>ref2
config>system>sync-if-timing>bits1
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode; not supported on 7210 SAS platforms configured in the standalone-VC
operating mode
Description
Note:
The config>system>sync-if-timing>ptp and config>system>sync-if-timing>bits1 contexts
are not supported on the 7210 SAS-Sx 10/100GE and 7210 SAS-S 1/10GE platforms.
This command configures the QL value to be used for the reference for SETS input selection and BITS
output. This value overrides any value received by that reference's SSM process.
Default
no ql-override
Parameters
prs
Specifies the SONET Primary Reference Source Traceable.
stu
Specifies the SONET Synchronous Traceability Unknown.
st2
Specifies the SONET Stratum 2 Traceable.
tnc
Specifies the SONET Transit Node Clock Traceable.
st3e
Specifies the SONET Stratum 3E Traceable.
st3
Specifies the SONET Stratum 3 Traceable.
prc
Specifies the SDH Primary Reference Clock Traceable.
ssu-a
Specifies the SDH Primary Level Synchronization Supply Unit Traceable.
ssu-b
Specifies the SDH Second Level Synchronization Supply Unit Traceable.
sec
Specifies the SDH Synchronous Equipment Clock Traceable.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
450
SPACER TEXT