Nokia 7210 SAS-Mxp - Page 449

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
commit
Syntax
commit
Context
config>system>sync-if-timing
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode; not supported on 7210 SAS platforms configured in the standalone-VC
operating mode
Description
This command saves changes made to the system synchronous interface timing configuration.
ptp
Syntax
ptp
Context
config>system>sync-if-timing
Platforms
7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx 1/10GE (standalone), 7210 SAS-Sx
10/100GE, and 7210 SAS-T (network and access-uplink)
Description
Commands in this context configure parameters for system timing via IEEE 1588-2008, Precision Time
Protocol.
This command is only available on the systems supporting the 1588-2008 frequency recovery engine.
ql-override
Syntax
ql-override {prs | stu | st2 | tnc | st3e | st3 | sec | prc | ssu-a | ssu-b}
no ql-override
Context
config>system>sync-if-timing>ptp
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
449
SPACER TEXT