Nokia 7210 SAS-Mxp - Page 472

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Description
This command forces a switchover to the standby CPM/CFM card. The primary CPM/CFM reloads its
software image and becomes the secondary CPM/CFM.
Parameters
now
Keyword to force the switchover to the redundant CPM/CFM card immediately.
switchover-exec
Syntax
switchover-exec file-url
no switchover-exec
Context
config>system
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC
Description
This command specifies the location and name of the CLI script file executed following a redundancy
switchover from the previously active CPM/CFM card. A switchover can happen because of a fatal failure
or by manual action.
The CLI script file can contain commands for environment settings, debug (excluding mirroring settings),
and other commands not maintained by the configuration redundancy.
The following commands are not supported in the switchover-exec file: clear, configure, candidate, oam,
tools, oam, ping, traceroute, mstat, mtrace and mrinfo.
If the file-url parameter is not specified, no CLI script file is executed.
Parameters
file-url
Specifies the location and name of the CLI script file.
Values file url — local-url | remote-url
255 chars max
local-url — [cflash-id/] [file-path]
remote-url — [{ftp:// | tftp://} login:pswd@remote-locn/] [file-path]
cflash-id — cf1:, cf1-A:, cf1-B:, cf2:, cf2-A:, cf2-B:, cf3:, cf3-A:, cf3-B:
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
472
SPACER TEXT