7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
rollback-sync
Syntax
[no] rollback-sync
Context
config>redundancy
Platforms
7210 SAS-R6 and 7210 SAS-R12
Description
The command enables automatic synchronization of rollback checkpoint files between the active CPM
and inactive CPM. When automatic synchronization is enabled, a rollback save will cause the new
checkpoint file to be saved on both the active and standby CPMs. The suffixes of the old checkpoint files
on both active and standby CPMs are incremented. Automatic synchronization only causes the ONE new
checkpoint file to be copied to both CFs (the other 9 checkpoints are not automatically copied from active
to standby but that can be done manually with admin>red>rollback-sync).
Automatic synchronization of rollback checkpoint files across CPMs is only performed if the rollback-
location is configured as a local file-url (for example, "cf3:/rollback-files/rollback). Synchronization is not
done if the rollback-location is remote.
Note:
The config red sync {boot-env | config} and admin red sync {boot-env | config} commands
do not apply to rollback checkpoint files. These commands do not manually or automatically sync
rollback checkpoint files. The dedicated rollback-sync command must be used to sync rollback
checkpoint files.
synchronize
Syntax
synchronize {boot-env | config}
no synchronize
Context
config>redundancy
Platforms
7210 SAS-R6 and 7210 SAS-R12
Description
This command enables automatic synchronization of the standby CPM/CFM’s images and config files to
the active CPM/CFM. Either the boot-env or config parameter must be specified.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
473
SPACER TEXT
To Next Page
Loading...