Nokia 7210 SAS-Mxp - Page 490

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Parameters
lag-id
Specifies the LAG identifier, expressed as a decimal integer. Specifying the lag-id allows
the mismatch between lag-id on the redundant pair. If no lag-id is specified, it is assumed
that the neighbor system uses the same lag-id as a part of the given MC-LAG. If no
matching MC-LAG group can be found between neighbor systems, the individual LAGs will
operate as usual (no MC-LAG operation is established).
Values 1 to 25
lacp-key admin-key
Specifies a 16 bit key that needs to be configured in the same manner on both sides of the
MC-LAG in order for the MC-LAG to come up.
Values 1 to 65535
system-id system-id
Specifies a 6 byte value expressed in the same notation as MAC address.
Values xx:xx:xx:xx:xx:xx
xx — 00 to FF
remote-lag remote-lag-id
Specifies the LAG ID on the remote system.
Values 1 to 800
system-priority system-priority
Specifies the system priority to be used in the context of the MC-LAG. The partner system
will consider all ports using the same lacp-key, system-id, and system-priority as part of
the same LAG.
Values 1 to 65535
6.20.2.1.23 LLDP system commands
lldp
Syntax
lldp
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
490
SPACER TEXT