Nokia 7210 SAS-Mxp - Page 498

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Description
This command configures the maximum consecutive LLDPDUs transmitted.
Parameters
count
Specifies the maximum consecutive LLDPDUs transmitted.
Values 1 to 100
Default 5
tx-hold-multiplier
Syntax
tx-hold-multiplier multiplier
no tx-hold-multiplier
Context
config>system>lldp
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures the multiplier of the tx-interval.
Parameters
multiplier
Specifies the multiplier of the tx-interval.
Values 2 to 10
Default 4
tx-interval
Syntax
tx-interval interval
no tx-interval
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
498
SPACER TEXT