Nokia 7210 SAS-Mxp - Page 500

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Context
config>port>ethernet>lldp
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures destination MAC address parameters.
Parameters
bridge-mac
Specifies destination bridge MAC type to use by LLDP.
Values nearest-bridge — Specifies to use the nearest bridge
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC
Relay (TPMR)
nearest-customer — Specifies to use the nearest customer
admin-status
Syntax
admin-status {rx | tx | tx-rx | disabled}
Context
config>port>ethernet>lldp>dstmac
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command specifies the administratively desired status of the local LLDP agent.
Parameters
rx
Specifies that the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx
Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
information about the remote systems connected.
tx-rx
Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
500
SPACER TEXT