Nokia 7210 SAS-Mxp - Page 502

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Parameters
system
Specifies to use the system IP address. If this parameter is specified, the system address
will only be transmitted once it has been configured.
tx-tlvs
Syntax
tx-tlvs [port-desc] [sys-name] [sys-desc] [sys-cap]
no tx-tlvs
Context
config>port>ethernet>lldp>dstmac
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command specifies which LLDP TLVs to transmit.
The no form of this command reverts to the default.
Default
no tx-tlvs
Parameters
port-desc
Specifies that the LLDP agent should transmit port description TLVs.
sys-name
Specifies that the LLDP agent should transmit system name TLVs.
sys-desc
Specifies that the LLDP agent should transmit system description TLVs.
sys-cap
Specifies that the LLDP agent should transmit system capabilities TLVs.
6.20.2.1.25 System resource-profile commands
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
502
SPACER TEXT