7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Note:
• In some scenarios, reassigning a chunk of resources among features may require the node to
be rebooted. See the CLI description of the feature for more information.
• The egress internal TCAM pool of resources is available per node on the 7210 SAS-T,
7210 SAS-Sx/S 1/10GE (standalone), 7210 SAS-Sx 10/100GE, and 7210 SAS-Mxp. On the
7210 SAS-Sx/S 1/10GE (standalone-VC), 7210 SAS-R6, and 7210 SAS-R12, it is available as
a per-IMM pool of resources.
• It is possible to configure a resource profile per node or per card in a virtual chassis.
• The number of chunks and the number of resources per chunk varies for the 7210 SAS
platforms. Contact your Nokia technical support representative for more information.
• To be enabled, some features require the allocation of a specific number of chunks (greater
than 1). If the minimum number of chunks is not assigned, the system cannot allocate the
required resources to the feature, which causes the command associated with the feature to
fail.
acl-sap-egress
Syntax
acl-sap-egress [num-resources]
no acl-sap-ingress
Context
configure>system>resource-profile>egress-internal-tcam
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command enables the user to allocate maximum resources for use by egress filter policies using
any of the supported match criteria. This command limits the total amount of chunks allocated for use by
egress filter policies to the value specified by num-resources. In other words, the cumulative sum of chunks
allocated to different match criteria supported by filter policies cannot exceed the value configured with
num-resources.
Note:
• The resources in the egress-internal-tcam resource pool are shared with other features (for
example, SAP egress aggregate meter). To assign resources to this feature, resources may
be reallocated from other features by disabling the policies association with a SAP, and others.
• On the 7210 SAS platforms, some of the Egress ACL match criteria require a minimum
amount of resources greater than 1, to be allocated before the match criteria can be used. In
other words, use of SAP egress aggregate meter is mutually exclusive to use of egress ACLs
with the following match criteria - mac-ipv4 match, ipv6-128bit match, mac-ipv6-64bit match.
All these match criteria require a minimum of 2 resources. SAP egress aggregate meter and
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
510
SPACER TEXT
To Next Page
Loading...