Nokia 7210 SAS-Mxp - Page 515

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms Min value
(per node)
Max value
(per node)
Default
values
7210 SAS-Sx 1/10GE standalone-VC) 0 2 2
7210 SAS-S 1/10GE (per node) (standalone) 0 2 0
7210 SAS-S 1/10GE (standalone-VC) 0 2 2
7210 SAS-Sx 10/100GE (per node) 0 2 2
7210 SAS-R6 and 7210 SAS-R12 IMM-c (per
node)
0 2 2
7210 SAS-Mxp 0 2 0
7210 SAS-R6 and 7210 SAS-R12 IMMv2 and
IMM-c
0 2 0
mac-ipv6-64bit-match-enable
Syntax
[no] mac-ipv6-64bit-match-enable num-resources
Context
configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command allocates maximum resources for use by egress filter policies using MAC criteria or IPv6
criteria using only the upper 64-bits of the IPv6 addresses. The resources allocated are allocated on a first-
come-first-serve basis among service entities (for example, SAP and IP interface) using IPv6 64-bit and
MAC criteria egress filter policies.
The resources cannot be shared with any other egress filter policies that specify other match criteria. See
the 7210 SAS-Mxp, R6, R12, S, Sx, T Router Configuration Guide for more information about resource
allocation and fields available for use.
The no form of this command specifies that the software does not allocate any resources for use by egress
filter policies using MAC or IPv6 64-bit criteria. If no resources are allocated for use, the software fails
all attempts to associate a service entity (for example SAP and IP interface) with a filter policy using this
match criteria.
Default
no mac-ipv6-64bit-match-enable
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
515
SPACER TEXT