Nokia 7210 SAS-Mxp - Page 516

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Parameters
num-resources
Specifies the maximum amount of resources for use by this filter match criteria. A minimum
value of 2 (indicating two chunks of resources) must be allocated to use this match-criteria.
If not, association of a policy with mac and ipv6 64bit criteria to a SAP will fail. It is mutually
exclusive to use of SAP egress aggregate meter.
Values The following table lists the parameter values.
Table 46: Number of resources available for mac-ipv6-64bit-match-enable
Platforms Min value
(per node)
Max value
(per node)
Default
values
7210 SAS-T access-uplink mode (per node) 0 2 0
7210 SAS-T network mode (per node) 0 2 0
7210 SAS-Sx 1/10GE (per node) (standalone) 0 2 0
7210 SAS-Sx 1/10GE (standalone-VC) 0 2 0
7210 SAS-S 1/10GE (per node) (standalone) 0 2 0
7210 SAS-S 1/10GE (standalone-VC) 0 2 0
7210 SAS-Sx 10/100GE (per node) 0 2 0
7210 SAS-Mxp 0 2 0
7210 SAS-R6 and 7210 SAS-R12 IMMv2 and
IMM-c
0 2 0
mac-match-enable
Syntax
[no] mac-match-enable num-resources
Context
configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command allocates maximum resources for use by egress filter policies using MAC criteria. The
resources allocated are allocated on a first-come-first-serve basis among service entities (for example,
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
516
SPACER TEXT