Nokia 7210 SAS-Mxp - Page 517

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
SAP and IP interface) using MAC criteria egress filter policies. This option provides the use of all available
resources exclusively by MAC criteria egress filter policies and provides larger number of policies to be
used.
The resources cannot be shared with any other egress filter policies that specify other match criteria. See
the 7210 SAS-Mxp, R6, R12, S, Sx, T Router Configuration Guide for more information about resource
allocation and fields available for use.
The no form of this command specifies that the software does not allocate any resources for use by egress
filter policies using MAC criteria. If no resources are allocated for use, the software fails all attempts to
associate a service entity (for example, SAP and IP interface) with a filter policy using this match criteria.
Note:
It is possible to use MAC policies by allocating resources that are shared with other match
criteria. This option allows for better scaling.
Default
no mac-match-enable
Parameters
num-resources
Specifies the maximum amount of resources for use by this filter match criteria.
Values 0 to 2
Default 0
eth-cfm
Syntax
eth-cfm [num-resources]
no eth-cfm
Context
configure>system>resource-profile>egress-internal-tcam
Platforms
7210 SAS-R6 (IMMv2 and IMM-c) and 7210 SAS-R12 (IMMv2 and IMM-c)
Description
Note:
This command applies only to VPLS SAPs on IMMv2 and IMM-c.
Commands in this context allocate resources for CFM bidirectional MIPs in a VPLS service.
The no form of this command allows the MIPs to retain the Down MEP by de-allocating the resources.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
517
SPACER TEXT