Nokia 7210 SAS-Mxp - Page 518

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
On the 7210 SAS-R6 and 7210 SAS-R12, the system does not allocate any ETH-CFM resource slices by
default. The user must allocate ETH-CFM resource slices manually. The default number of resource slices
is 0 and a maximum of 1 slice can be allocated.
Parameters
num-resources
Specifies the maximum amount of resources for use by ETH-CFM. Entering a value of def
allocates the default number of resource slices.
Values The following table lists the parameter values.
Table 47: Number of resources available for eth-cfm
Platforms Min value Max value Default
7210 SAS-R6 0 1 0
7210 SAS-R12 0 1 0
7210 SAS-R6 and 7210 SAS-R12
IMM-c
29
0 1 0
bidir-mip-egress
Syntax
bidir-mip-egress [num-resources]
no bidir-mip-egress
Context
configure>system>resource-profile>egress-internal-tcam>eth-cfm
Platforms
7210 SAS-R6 (IMMv2 and IMM-c) and 7210 SAS-R12 (IMMv2 and IMM-c)
Description
This command allocates resources for the VPLS bidirectional MIP (both ingress and egress directions) on
SAPs only from the egress internal TCAM resource pool.
Note:
• The resources in the egress internal TCAM resource pool are shared with other features.
To assign resources to a specific feature, resources can be reallocated from other features.
For example, you can release resources by disabling the policies associated with a SAP.
29
Applicable only on SAPs.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
518
SPACER TEXT