Nokia 7210 SAS-Mxp - Page 530

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms Min value
(per node)
Max value
(per node)
Default
values
7210 SAS-T network mode (per node) 0 6 max
7210 SAS-R6 and 7210 SAS-R12 (per IMMv2) 0 12 max
7210 SAS-R6 and 7210 SAS-R12 (per IMM-c) 0 10 max
7210 SAS-Mxp (per node) 0 10 max
7210 SAS-Sx 1/10GE (per node) (standalone) 0 7 max
7210 SAS-Sx 1/10GE (standalone-VC) 0 6 max
7210 SAS-S 1/10GE (per node) (standalone) 0 7 max
7210 SAS-S 1/10GE (standalone-VC) 0 6 max
7210 SAS-Sx 10/100GE (per node) 0 3 max
ipv4-match-enable
Syntax
ipv4-match-enable num-resources
no ipv4-match-enable
Context
configure>system>resource-profile>ingress-internal-tcam>acl-sap-ingress
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command allocates maximum resources for use by ingress filter policies using IPv4 criteria.
The resource cannot be shared with ingress filter policies using mac criteria or ipv6 criteria. See the
7210 SAS-Mxp, R6, R12, S, Sx, T Router Configuration Guide for more information about resource
allocation and fields available for use.
Ingress ACL resources are shared with SAP ingress aggregate meter. See the sap-aggregate-meter
command for more information.
The no form of this command specifies that the software does not allocate any resources for use by
ingress filter policies using ipv4 criteria. If no resources are allocated for use, the software fails all attempts
to associate a service entity (for example, SAP and IP interface) with an ingress filter policy using this
match criteria.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
530
SPACER TEXT