Nokia 7210 SAS-Mxp - Page 538

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Context
configure>system>resource-profile>ingress-internal-tcam
Platforms
7210 SAS-Mxp and 7210 SAS-Sx/S 1/10GE (standalone)
Description
This command configures the resources required to classify and intercept DHCPv6 messages received on
SDP bindings (spoke SDP and mesh SDP in TLDP VPLS services).
Note: The user must first configure this command before DHCPv6 snooping can be enabled in
the SDP bindings context. Failure to do so causes the DHCPv6 snooping configuration to fail.
The no form of this command specifies that the software does not allocate any resources to process
DHCPv6 messages received on SDP bindings (spoke-SDP and mesh SDP).
Default
no dhcp-snooping-sdp-resource
Parameters
num-resources
Specifies the maximum resource allocation required to process DHCPv6 messages.
Values 0 to 1
eth-cfm
Syntax
eth-cfm num-resources
no eth-cfm
Context
configure>system>resource-profile>ingress-internal-tcam
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command allocates resources for CFM Up MEPs, CFM Down MEPs, ingress MIPs, and bidirectional
MIPs (ingress and egress MIPs).
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
538
SPACER TEXT