Nokia 7210 SAS-Mxp - Page 539

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Note:
On most 7210 SAS platforms, ingress MIPs and bidirectional MIP resources are allocated from
the Down MEP and Up MEP resource pool. See the down-mep and up-mep commands for more
information.
The no form of this command specifies that the software does not allocate any resources for use by CFM
UP MEPs, and it will allocate the default amount of resources for CFM Down MEPs.
Parameters
num-resources
Specifies the maximum number of resources available for use by ETH-CFM.
Values The following table lists the parameter values.
Table 57: Number of resources available for eth-cfm
Platforms Min value
(per node)
Max value
(per node)
Default
7210 SAS-T Access-Uplink mode (per node) 0 1 0
7210 SAS-T Network mode (per node) 0 1 0
7210 SAS-R6 and 7210 SAS-R12 (per
IMMv2)
1 3 1
7210 SAS-R6 and 7210 SAS-R12 (per IMM-
c)
1 3 1
7210 SAS-Mxp (per node) 1 3 1
7210 SAS-Sx 1/10GE (per node)
(standalone)
1 3 1
7210 SAS-Sx 1/10GE (standalone-VC) 2 4 2
7210 SAS-S 1/10GE (per node) (standalone) 1 3 1
7210 SAS-S 1/10GE (standalone-VC) 2 4 2
7210 SAS-Sx 10/100GE (per node) 1 3 1
down-mep
Syntax
down-mep num-resources
no down-mep
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
539
SPACER TEXT