Nokia 7210 SAS-Mxp - Page 540

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Context
configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Platforms
7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx/S 1/10GE, and 7210 SAS-Sx 10/100GE
Description
This command enables the user to allocate more resources and increase the number of CFM/Y.1731 Down
MEPs. By default, the system allocates a single slice for use with Down MEP.
Resources from this pool are allocated towards the following:
• down MEP on SDP binding
• on the 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE (standalone), and 7210 SAS-Sx 10/100GE
(standalone), ingress and egress MIPs for Epipe SAPs and Epipe SDP bindings
• on the 7210 SAS-R6 and 7210 SAS-R12, ingress and egress MIPs (that is, bidirectional MIPs) for Epipe
SAPs and Epipe SDP bindings
Note:
On the 7210 SAS-R6 and 7210 SAS-R12, bidirectional MIPs also use the Up MEP resource
pool.
• On the 7210 SAS-R6 and 7210 SAS-R12, this is a per-IMM resource. For SAPs, the resources are
required only on the IMM for which the SAP is allocated. For SDP bindings, resources are required on
all IMMs because MPLS packets could be received on any network port.
• Some entries are reserved for system internal use.
The no form of this command is not supported. At least a single slice must be allocated for use with Down
MEPs because some of the resources are reserved for system internal use. The software enforces it and
errors out an attempt to change it to a value less than 1.
Parameters
num-resources
Specifies the maximum amount of resources for use by down-mep.
Values 1 to 3
Default 1
sap-down-mep
Syntax
sap-down-mep num-resources
no sap-down-mep
Context
configure>system>resource-profile>ingress-internal-tcam>eth-cfm
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
540
SPACER TEXT