Nokia 7210 SAS-Mxp - Page 542

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Parameters
num-resources
Specifies the maximum amount of resources for use by Down MEPs on SDPs and ingress
MIPs.
Values 1 to 2
up-mep
Syntax
up-mep num-resources
no up-mep
Context
configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command allocates resources for CFM Up MEPs.
Resources for Up MEPs created on SAPs and SDP bindings are allocated from this pool.
Note:
• On the 7210 SAS-R6 and 7210 SAS-R12, when an Up MEP on an SDP binding is created,
resources are allocated for the Up MEP on all IMMs, and when an Up MEP on a SAP is
created, resources are allocated only on the IMM for which the SAP is configured or on the set
of IMMs if the SAP is configured over a LAG.
• On the 7210 SAS-R6 and 7210 SAS-R12, resources from this pool are used only for Up MEPs
configured in Epipe services. Up MEPs configured in a VPLS service use resources from a
different pool.
• On the 7210 SAS-R6 and 7210 SAS-R12, and on the 7210 SAS-Sx/S 1/10GE operating in
standalone-VC mode, resources from this pool are also used for bidirectional MIPs configured
on Epipe SAPs and Epipe SDP bindings.
The no form of this command specifies that the software does not allocate any resources for use by CFM
Up MEPs. If no resources are allocated for use, the software fails all attempts to configure an Up MEP and
bidirectional MIPs on applicable platforms (see preceding Note).
Default
up-mep 0
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
542
SPACER TEXT