Nokia 7210 SAS-Mxp - Page 549

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms Min value
(per node)
Max value (per
node)
Default
values
7210 SAS-Sx 1/10GE (per node)
(standalone)
0 7 4
7210 SAS-Sx 1/10GE (standalone-VC) 0 6 4
7210 SAS-S 1/10GE (per node)
(standalone)
0 7 4
7210 SAS-S 1/10GE (standalone-VC) 0 6 4
7210 SAS-Sx 10/100GE (per node) 0 3 3
qos-sap-egress-resource
Syntax
qos-sap-egress-resource num-resources
no qos-sap-egress-resource
Context
config>system>res-prof>ing-internal-tcam
Platforms
7210 SAS-R6 and 7210 SAS-R12 (only supported on IMMv2 cards; not supported on IMM-c cards)
Description
This command configures resource allocation for SAP-based egress queuing. If port-based queuing is
disabled, then users must allocate resources for SAP-based egress queuing using this command. If no
resources are allocated, SAPs cannot be created.
When port-based queuing is enabled, resources can be taken away from SAP-based egress queues and
allocated to other features that share the ingress-internal-tcam pool (for example, SAP ingress qos and
Ingress ACLs).
The no form of this command reverts to the default value.
Default
0
Parameters
num-resources
Specifies the amount of resources that are allocated towards SAP-based egress queues.
Values 0 to 2
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
549
SPACER TEXT