7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
When port-scheduler-mode is enabled, software allocates 8 egress queues per port and all the SAPs
configured on the access port or hybrid port will share the 8 egress queues for traffic sent out of that port.
In this mode, SAPs configured on hybrid port shares the egress queues with network port traffic. Enabling
port-scheduler-mode affects the behavior for all the SAPs configured on all the access and hybrid port. In
this mode, per SAP egress queues are not available.
In this mode, resources allocated towards SAP egress queues in the ingress-internal-tcam pool are not
required by this feature and can be allocated towards other features. See the qos-sap-egress-resource
command for more information.
The no form of this command disables port-scheduler-mode, causing per SAP egress queues to be
available for use. See the 7210 SAS-Mxp, R6, R12, S, Sx, T Quality of Service Guide for more information
about the two modes.
Enabling or disabling port-scheduler-mode requires a reboot of the node.
Default
no port-scheduler-mode
router
Syntax
router
Context
configure>system>resource-profile
configure>system>global-res-profile
Platforms
Supported on all 7210 SAS platforms as described in this document
Description
Note:
The configure>system>resource-profile context is supported on the 7210 SAS-T, 7210 SAS-
Mxp, 7210 SAS-Sx/S 1/10GE: standalone, and 7210 SAS-Sx 10/100GE.
The configure>system>global-res-profile context is supported on the 7210 SAS-R6,
7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC.
Commands in this context configure router parameters that is applicable to the entire chassis (in other
words it applies to all IMMs).
ecmp
Syntax
ecmp max-routes-dest
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
554
SPACER TEXT
To Next Page
Loading...