7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
Specifies the type-of-service (TOS) bits in the IP header of the ping packets, expressed as
a decimal integer.
Values 0 to 255
size bytes
Specifies the size in bytes of the ping request packets.
Default 56 bytes (actually 64 bytes because 8 bytes of ICMP header data are
added to the packet)
Values 0 to 65507
pattern pattern
Specifies a 16-bit pattern string to include in the ping packet, expressed as a decimal
integer.
Values 0 to 16384
source ip-address
Specifies the source IP address to use in the ping requests in dotted-decimal notation.
Default The IP address of the egress IP interface.
Values ipv4-address - a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:x:x [-interface]
x:x:x:x:x:x:d.d.d.d
x: 0 — FFFF H
d: 0 — 255 D
interval seconds
Specifies the interval in seconds between consecutive ping requests, expressed as a
decimal integer.
Default 1
Values 1 to 10000
next-hop ip-address
This option disregards the routing table and will send this packet to the specified next hop
address. This address must be on an adjacent router that is attached to a subnet that is
common between this and the next-hop router.
Default per the routing table
Values
ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x[-interface]
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
64
SPACER TEXT
To Next Page
Loading...