Nokia 7210 SAS-Mxp - Page 63

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command is the TCP/IP utility to verify IP reachability.
Parameters
ip-address | dns-name
Specifies the remote host to ping. The IP address or the DNS name (if DNS name
resolution is configured) can be specified.
Values ipv4-address - a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:x:x [-interface]
x:x:x:x:x:x:d.d.d.d
x: 0 — FFFF H
d: 0 — 255 D
rapid | detail
The rapid keyword specifies to send ping requests rapidly. The results are reported in a
single message, not in individual messages for each ping request. By default, five ping
requests are sent before the results are reported. To change the number of requests,
include the count option.
The detail keyword includes in the output the interface on which the ping reply was
received.
The following is a sample configuration.
*A:ALU-7210# ping 192.xxx.xxx.xxx
PING 192.xxx.xxx.xxx 56 data bytes
64 bytes from 192.xxx.xxx.xxx: icmp_seq=1 ttl=64 time<10ms.
64 bytes from 1192.xxx.xxx.xxx: icmp_seq=2 ttl=64 time<10ms.
64 bytes from 192.xxx.xxx.xxx: icmp_seq=3 ttl=64 time<10ms.
64 bytes from 192.xxx.xxx.xxx: icmp_seq=4 ttl=64 time<10ms.
64 bytes from 192.xxx.xxx.xxx: icmp_seq=5 ttl=64 time<10ms.
---- 192.xxx.xxx.xxx PING Statistics ----
5 packets transmitted, 5 packets received, 0.00% packet loss
round-trip min < 10ms, avg < 10ms, max < 10ms, stddev < 10ms
*A:ALU-7210#
ttl time-to-live
Specifies the IP Time To Live (TTL) value to include in the ping request, expressed as a
decimal integer.
Values 0 to128
tos type-of-service
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
63
SPACER TEXT