Nokia 7210 SAS-Mxp - Page 646

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Context
show>redundancy
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC
Description
This command displays redundancy synchronization times.
Output
The following output is an example of redundancy synchronization information, and Table 87: Output fields:
synchronization describes the output fields.
Sample output
A:ALA-48>show>redundancy# synchronization
===============================================================================
Synchronization Information
===============================================================================
Standby Status : disabled
Last Standby Failure : N/A
Standby Up Time : N/A
Failover Time : N/A
Failover Reason : N/A
Boot/Config Sync Mode : None
Boot/Config Sync Status : No synchronization
Last Config File Sync Time : Never
Last Boot Env Sync Time : Never
===============================================================================
A:ALA-48>show>redundancy#
Table 87: Output fields: synchronization
Label Description
Standby Status Displays the status of the standby CSM
Last Standby Failure Displays the timestamp of the last standby failure
Standby Up Time Displays the length of time the standby CSM has been up
Failover Time Displays the timestamp when the last redundancy failover
occurred causing a switchover from active to standby CSM
If there is no redundant CSM card in this system or no failover
has occurred since the system last booted, the value will be 0.
Failover Reason Displays a text string giving an explanation of the cause of the
last redundancy failover
If no failover has occurred, an empty string displays.
Boot/Config Sync
Mode
Displays the type of synchronization operation to perform
between the primary and secondary CSMs after a change has
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
646
SPACER TEXT