Nokia 7210 SAS-Mxp - Page 648

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
sync-if-timing
Syntax
sync-if-timing
Context
show>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode; not supported on 7210 SAS platforms configured in the standalone-VC
operating mode
Description
This command displays synchronous interface timing information.
Output
The following outputs are examples of synchronous interface timing information, and Table 89: Output
fields: sync interface timing describes the output fields.
• Sample output for 7210 SAS-R6 and 7210 SAS-R12
• Sample output for 7210 SAS-T and 7210 SAS-Mxp
• Sample output for 7210 SAS-Sx/S 1/10GE
• Sample output for 7210 SAS-Sx 10/100GE
Sample output for 7210 SAS-R6 and 7210 SAS-R12
*A:sasr_dutb>show>system# sync-if-timing
===============================================================================
System Interface Timing Operational Info
===============================================================================
System Status CPM A : Master Free Run
Reference Input Mode : Non-revertive
Quality Level Selection : Disabled
Reference Selected : none
System Quality Level : st3
Reference Order : bits1 ref1 ref2 ptp
Reference Mate CPM
Qualified For Use : No
Not Qualified Due To : LOS
Selected For Use : No
Not Selected Due To : not qualified
Reference Input 1
Admin Status : down
Rx Quality Level : unknown
Quality Level Override : none
Qualified For Use : No
Not Qualified Due To : disabled
Selected For Use : No
Not Selected Due To : disabled
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
648
SPACER TEXT